PU Foam Applicator Gun - Polyurethane Teflon Coated Expanding Insulation BC-1573

Polyurethane Foam Applicator, ideal for sealing, filling and insulating small gaps. It is a solid and durable, lightweight and compact tool, ergonomically designed to use for longer periods.Easy to clean and a sprung trigger to accurately control flow.SpecificationsModel: BC-1573Polyurethane Foam Applicator GunCE certificationPower Source:ManualGun Trigger Material:Steel with Teflon CoatingGun Tube Material:Steel with Teflon CoatingSize:750ml & 500mlGun Dimensions: 32.5cm (L)x 20cm(W)Tube Length: 18.5cmNozzle Diameter: 2mmGun End Nozzle:BrassGun Colour: Black and RedFeaturesErgonomic DesignDouble Colour Rubber HandleTeflonCoated for easy, non scratch cleaning.Corrosion and wear resistantSprung control triggerPackageComes packed in a cardboard triangle box.1 x PU Foam Applicator Gun1 x Plastic Tube2 x Plastic NozzleDirections for use of the foam gunTake a can of gun foam and shake vigorously.Screw can on to adapter of gun(not too tight).Release the flow adjustment screw lightly and dispense foam immediately to fill the entire gun with foam.The foam gun i snow ready to use.Foam output can be controlled with flow adjustment screw.After use of the foam gunLeave gun filled with foam after use.Always keep a filled can of gun foam on the gun.Tighten the flow adjustment screw completely.Do not empty the gun.Gun must always be filled with foam,otherwise foam is cured due to the humidity in the air.Put can away in a vertical position(gun upwards).Use foam gun againShake the can vigorously(keep hold of the gun).Remove cured foam at the tip of the nozzle carefully with a small,sharp knife.Release the flow adjustment screw lightly and dispense foam immediately until the flow of foam is correct.The gun is now ready to use.Foam output can be controlled with trigger of the gun.Replacing of the can gun foamCheck if the can is empty by dispensing foam in a dust-bin until no more foam is released.Take a new can of gun foam.Shake vigorously.Unscrew the empty can(keep valve opening away from you),remove released foam from adapter and replace the empty can immediately by a new one.Dispense foam immediately to fill the extension tube.Cleaning of the foam gun at times of interruptionUnscrew the can of gun foam (keep valve opening away from you).Take a can gun cleaner and screw the can on the gun.Pull the trigger again to refill the gun with cleaner.Cleaner has to remain in the gun for about 5 minutes.Pull the trigger again to refill the gun with cleaner.Unscrew the can gun cleaner.Screw the can gun foam onto the gun.Pull trigger of the gun again until foam is released and cleaner completely removed.The gun is now ready to use.